Installation

Simple Step Guide for Installing a Mirror Demister
  • Mark out the back of the mirror to indicate where the mirror demisting pad is to be fitted
  • Peel off the protective paper exposing the 'sticky' side of the mirror demister
  • Position one edge of the mirror demister pad in the desired position on the keeping the other edge away from the mirror
  • Gradually lower the pad onto the mirror applying even pressure to ensure there are no air bubbles or creases
  • If the mirror is not framed & is being fitted directly onto the wall, a small recess will need to be made in the wall to compensate for this & allow the mirror to sit flush.

Download a copy of the fitting instructions here

Electrical Connections

All wiring must conform to the latest IEE wiring regulations ( BS7671 equivalent).

  • It is recommended that the mirror demisters pad is connected via the lighting circuit or on a separate switch.
  • The circuit should be protected by a 5amp fuse or circuit breaker
  • The wires are coloured as follows: BLUE - Neutral, and BROWN - Live/positive
  • The mirror Demisters pad must not be accessible once installed
  • Any metal part surrounding the mirror must be earthed & comply with current wiring regulations
  • Multiple pads may be fitted to a single mirror & should be connected in parallel - pads must not overlap

The mirror demister pad must not be cut or pierced as this may damage the insulation making it unsafe.

mirror demisters