Simple Step Guide for Installing a Mirror Demister

1) - Mark out the back of the mirror to indicate where the mirror demisting pad is to be fittedeel off the protective paper exposing the 'sticky' side of the mirror demister

2) - Position one edge of the mirror demister pad in the desired position on the keeping the other edge away from the mirror

3) - Gradually lower the pad onto the mirror applying even pressure to ensure there are no air bubbles or creases

4) - If the mirror is not framed & is being fitted directly onto the wall, a small recess will need to be made in the wall to compensate for this & allow the mirror to sit flush.

Download a copy of the fitting instructions here

Electrical Connections

All wiring must conform to the latest IEE wiring regulations ( BS7671 equivalent)

It is recommended that the mirror demisters pad is connected via the lighting circuit or on a separate switch.

The circuit should be protected by a 5amp fuse or circuit breaker

The wires are coloured as follows: BLUE - Neutral, and BROWN - Live/positive

The Mirror Demister pad must not be accessible once installed

Any metal part surrounding the mirror must be earthed & comply with current wiring regulations

Multiple pads may be fitted to a single mirror & should be connected in parallel - pads must not overlap

The mirror demister pad must not be cut or pierced as this may damage the insulation making it unsafe.